Glass patio doors incidentally need to be removed from the home. The holder may covet an alternate sort of door or move toward replacing the glass patio door with a more current, more energy-efficient model. In either case, the first stage of the procedure is uprooting the old door and its partnered frame and hardware. A patio door evacuation venture falls inside the do-it-yourself classification with no specific tools needed, despite the fact that a little help may be required to remove the heavier components, for example the doors themselves.
- Remove the interior trim from the door. Pry it detached painstakingly using a modest, even pry bar and set it aside for use with the new door, if relevant.
- Remove the sections holding the fixed side of the sliding door in place. There are usually two sections, one at the top and one at the bottom, held in place with screws. Slide the fixed parcel to the core of the door frame, lift the bottom from the track and remove it from the range.
- Remove the holding cuts or strips from the sliding door track. These strips anticipate the door from sliding too far. When they are removed the door could be slid to the core and lifted out in the same way as the fixed side of the door.
- Remove nails holding the door frame or packaging in place. These nails usually experience the door packaging into the stud divider.
- Use an utility knife to cut any caulking between the exterior trim and the divider. Remove the exterior trim and set it aside for conceivable later use.
- Slide the door packaging out of the opening. As the packaging slides out, tip the bottom to permit more clearance at the top. When the door packaging is clear of the stud divider opening, remove it from the work zone.